Ünver Makina
Products - Edge Banding Machines - BANTMATİK 334 EDGE BANDING MACHINE
Detail Technical Informations Settlement plan Catalog

MACHINE LENGHT 3,3 METERS FROM DOOR TO DOOR. IT HAS PLC CONTROL PANEL AND 4 UNITS. WORKING SPEED IS 15 METER/MINUTE.

 

AIR COMPRESOR WITH AIR DRYER, DUST SUCTION MACHINE AND REGULATOR MUST BE USED FOR MACHINE. START-UP, INSTALLATION AND MAINTENANCE SHOULD BE DONE FROM UNVER WOODWORKING MACHINERY QUALIFIED TECHNICIANS. IF YOU DONT OBEY CONDITIONS, YOUR MACHINE LIFESPAN WILL SHORTEN. IT WILL NOT INCLUDED WARRANTY.

PANEL BOARD

Use fastly with Pc controlling unit. Pratical and easy to use. Reach all past defect.You can learn total material and pvc band length.

Pre Heater Profile

The front surfaces are heated and dried by resistance heating at 80 degrees to prevent moisture and sweating.

GLUE UNIT 4 liter glue capacity, ready 5-15 minutes. Stiffened and annealed glue roller.Preview glue stcik system. 4 kh bearing, back spring concept.
PRESS UNIT Press roller is adjusted by pressure, it rotates same as a palet speed. There are 3 press roller which is pressure adjusted. Press platform’s back and forward movement calibrated by indicator easily.
BEGINNING-END MILLING 45° angled, pair of linear sled beginning-end milling unit. At 1200 rpm, it cuts beginning-end sensitively with high frequency motors.
BOTTOM-TOP MILLING

It can cut till 30°, using preview disk bright surfaces can milling without scratch.at 18000 rpm sensitive surfaces can milling with high frequency motors. Band thickness can control 0,4 - 3 mm accurately by indicator. All excelsiors absorbed by dust suction.

R2 RADIUS Using preview disk bright surfaces can scraping with radius. 0,4 - 3 mm band thickness adjustment calibrated by indicator easily
POLISHING UNIT 15 angled, forward-back and down-up polishing motors obtain clean and bright surfaces.
DUST SUCTION

1600 m3 dust suction fan absorb all pvc excelsiors from pre-milling and bottom-top milling.

TECHNICAL INFORMATIONS

BANTMATİK 334 TR-PC

MAXIMUM PANEL THICKNESS

8 MM / 60 MM.

BAND THICKNESS

0,4 MM / 5 MM.

MINIMUM PANEL LENGTH

120 MM

MINIMUM PANEL WIDTH

100 MM

GLUE CAPACITY

3 LT / 4 KG.

GLUE HEATING TIME

20-25 MINUTE

WORKING SPEED

15 M/MIN

 END MILLING CUTTER MOTORS (2 PIECES)

0,37 KW 12.000 R.P.M

BOTTOM-TOP MILLING CUTTER MOTORS (2 PIECES)

0,55 KW 18.000 R.P.M

BUFFER MOTORS (2 PIECES)

0,25 KW / 3.000 R.P.M

DUST SUCTION MOTOR

0,75 KW 1.600 M3

POWER

8 KW

VOLTAGE

380 – 400 V / 50–60 HZ

CURRENT

22 AMPER

WORKING PRESSURE

4/6 BAR

TRANSPORTATION DIMENSIONS LENGHT - WIDTH - HEIGHT

4.2 X 0.75 X 1.5 M

WEIGHT

1.28025 KG